HIHELO Small Equipment Accessories Solenoid Valve Electromagnetic Valve for Non-Pressure Solar Water Heater Upload Water Automatically

Installing electromagnetic valve Before installing electromagnetic valve, please clean up and wash pipe. If water is provided by water tower, please select electromagnetic valve, which caters the water pressure of water tower. So to avoid the low flow rate or even no water flows from electromagnetic valve. Check whether the output voltage of controller caters to the label voltage of electromagnetic valve; check whether the filter net is completed, whether the body of electromagnetic valve is completed. Outlet and inlet of electromagnetic valve should be right installed, the side with filter net is input, and water flow direction should be same as the arrow which marked on the body of electromagnetic valve. Electromagnetic should be installed in the place where is easy to maintain and does not bring other lose, please take measures for antifreezing, anti-sunburn and therefore to avoid aging of body of valve and to prolong the lifetime of valve. Please pay attention to install the wire coil upwards. It is forbidden to use wrench to work on the wire coil and on plastic part. The inlet and outlet pipe of electromagnetic valve should be keep at a same level, and ensure not to mount valve compulsively when both connection parts are not at a same level, and therefore to avoid damaged of valve. It should be noted that installed valve doesn’t bear the torsional strength which caused by wrong mounted pipe. Two-cores wire should be connected with electromagnetic valve, when wire need to be prolonged, please select 1.0mm 2 cable. The pipe, which is connected with valve, should be easy to dismount or use flexible pipe, it should be easy to clean the filter. Switch-on power and check valve after installation. Note: electromagnetic valve has check-valve function, it is not necessary to install one way valve any more.